Aircrack-ng forum
General Category => Newbies => Topic started by: empahpsy on December 31, 2016, 02:49:26 pm
-
Hi guys!
After hours of researching I will try and find my answers here.
I'm using Retina MacBook Pro 13', running Kali Live USB Persisten on it.
Network adapter which is, Chipset: BCM43602, PCI device ID: 14e4:43ba.
Now at linuxwireless.org it says that the Network Adapter is supported, but does it support Aircrack-ng?
I'm getting a error message when [Airmon-ng start wlan0], says it's not supported(-95).
Do I need to install the designated driver, or does it not support my network adapter at all?
Humbly thanks in for forehand.
Best regards,
EmphaPsy
-
Partial error messages are useless. Post full error messages.
-
Hi,
I own a MacBook Pro (Retina, 15-inch, Early 2013) and i wanted to know if there is a way to put my wireless card in monitor mode, This is what I get if i enter iwconfig command in kali terminal:
root@kali:~# iwconfig
eth0 no wireless extensions.
lo no wireless extensions.
root@kali:~#
My wireless interface report:
en0:
Card Type: AirPort Extreme (0x14E4, 0xEF)
Firmware Version: Broadcom BCM43xx 1.0 (7.21.171.68.1a5)
Thanks in advance for any help.
-
I have the same MacBook model and I have yet to find a solution.
Did find this though: https://www.aircrack-ng.org/~~V/doku.php?id=b43
Seems PCI ID 14e4:43ba is simply not supported.
Can they add support for this?